NPP Projection Report 8/11 Admin
To do this evening/ was completed:
Presentation Issues:
Preshow Clips/Playlist: Went through all of the LMS schedule for next week with the updated schedule Matthew sent out last night and made all necessary adjustments.
Trailer Updates:
Special Events/ AV set up: 1.37 lenses and plates in place in T1, ran loops on both projectors.
Ran a loop in T4 for Odyssey. Cleaned the platter and projector before threading.
Ordering/Receiving (posters & trailers):
Ordering/Receiving (content):
Outgoing/Shipping (content): Reached out to HFC for Beavis return labels.
Print/video Inspection: I was just checking the Crash inspection report to see if it had all been inspected. This is 1.66, not 1.85! I changed that in the report.
Ordering/Receiving (posters & trailers):
Ordering/Receiving (content):
Outgoing/Shipping (content): Reached out to HFC for Beavis return labels.
Print/video Inspection: I was just checking the Crash inspection report to see if it had all been inspected. This is 1.66, not 1.85! I changed that in the report.
Looked at Heat Lightning with Cristina. It's pretty quiet so we set the volume to 10. cues added to the playlist.
Cue sheets updated/checked (every shift): Built cue sheets for next week. Credit times missing for SE DCPs that still need to be teched (Bottle Rocket, Onda Nova, Trees Lounge) and most timing for Top gun is missing since the event memo isn't done yet.
Marquee updated?:
Posters updated?: Yes; Minions down, Paw Patrol up.
Cleaning lights on for the night?:
Projection cart by entrance?:
Additional Notes:
We also went through the playlist to check the preshow and the short. All good!
Asset tracking doc updated/checked?:
Maintenance/cleaning: I emailed everyone about this but mentioning it here, too. The bottom roller on projector 1 seems like it's completely normal. When no film is engaged on it, it spins freely like it's supposed to. It also was spinning when I ran test film onto the platter. When I went to thread Odyssey, it spun normally when I ran the frameline leader through but, after I turned the motor over by hand using the flywheel, it did not spin when I switched the motor on again to check. So I think it has something to do with stopping the motor, advancing by hand, then starting the motor again that's causing it to freeze up. Just wiggle it gently forward/backward along the metal shaft after starting the show and it should start spinning again.
Asset tracking doc updated/checked?:
Maintenance/cleaning: I emailed everyone about this but mentioning it here, too. The bottom roller on projector 1 seems like it's completely normal. When no film is engaged on it, it spins freely like it's supposed to. It also was spinning when I ran test film onto the platter. When I went to thread Odyssey, it spun normally when I ran the frameline leader through but, after I turned the motor over by hand using the flywheel, it did not spin when I switched the motor on again to check. So I think it has something to do with stopping the motor, advancing by hand, then starting the motor again that's causing it to freeze up. Just wiggle it gently forward/backward along the metal shaft after starting the show and it should start spinning again.
Cue sheets updated/checked (every shift): Built cue sheets for next week. Credit times missing for SE DCPs that still need to be teched (Bottle Rocket, Onda Nova, Trees Lounge) and most timing for Top gun is missing since the event memo isn't done yet.
Marquee updated?:
Posters updated?: Yes; Minions down, Paw Patrol up.
Cleaning lights on for the night?:
Projection cart by entrance?:
Additional Notes:
Comments
Post a Comment